All J Products - Custom Work

Custom Work

At All J Products we do custom fabrication, install 4x4 suspension systems, and can build or install just about anything you need for your Jeep. Custom Boulder Bars and Bumpers can be made for any Jeep vehicle! We just need to have the vehicle in the shop for fitting. Send us an e-mail or give us a call, and let us know what you need. Some of the custom items we have built for customers are pictured below. We have done everything from suspension lifts, and custom fabrication, to all out custom bumpers and racks! We build your trail rig for you, the way you want it, totally ready for any trail.

This 1982 CJ8 Scrambler features a '97 Chevy 350 Vortech V8, 4L80E auto tranny, Dana 300 t-case, Dana 44 axles with ARB Air Lockers and 4.88 gears. The suspension features a spring over lift with Wrangler springs, Rancho 9000 shocks and a MORE shackle reversal. Tires are 35" Mickey Thompson Bias Claws mounted on Outlaw 2 wheels. Other parts include: Part's Mike hi-steer arms, Bestop seats, Wrangler mirror conversion, Arrow 33 gallon fuel tank and more. You will also find our new CJ8 Boulder Bars, All J front bumper and our new custom rear CJ8 wrap around rear bumper! We also built a rack over the rear bed cover between the roll bar. How does the Jeep work? Well after a short test run in Big Bear, we loaded it up, hitched on an Adventure Trailer and drove to the Rubicon Trail. We ran the Rubicon pulling the trailer, then drove all the way back. A successful maiden voyage for sure, we didn't expect anything less from this Jeep!

On this 1998 TJ, we built the custom overhead storage rack, using custom parts and supports to hold up a Con-Ferr roof rack! Below, we also built our rear tire rack with a custom sized Con-Ferr rack and gas can holders! This TJ is also equipped with All J's front & rear bumpers and Boulder Bars. More mods include, PIAA lighting, Onboard air from Kilby, Gas tank Skid from Kilby, Rancho Rock Crawler lift boosted to 5" with lots of custom parts, Advance Adapters SYE, 35" MT/R's, Tera Low, Currie steering rod conversion, and more!

Long arm suspensions, custom lifts or complete vehicles! All J Products can build just about anything you want.

To the left is one of our shop Jeeps. It has Boulder Bars, an All J Front Bumper with a Warn winch, an All J Rear Bumper, a TJ Storage Box, an Nth DEGREE 6" long arm PLUS a 5.5" Nth Degree Stretch Kit, a high clearnce belly pan, an engine skid, 35" tires, a custom installed Dana 44 rear axle, our own custom tire rack with Rubicon style basket, PIAA lighting, Kilby On Board Air and much more.

There's just TOO much cool stuff on this Jeep TJ to list! Hover over the photo to the left for a larger picture.

When Mario Donovan from AdventureTrailers.com needed a new rear bumper for his Jeep Comanche, he needed a bumper strong enough to tow his off-road camping trailers. His previous bumper had cracked from this type of use. Our task? Build Mario a bumper that would look good, hold up to the job of towing and wheeling, and if possible offer some protection for the Comanche's rear overhang. So how did All J Products do? Here are Mario's own words: "My bumper is doing the tow duty beautifully. Thank you for your great craftsmanship." This custom Jeep MJ rear bumper was built from 2"x6"x3/16 thick box tubing. The mounts were plasma cut from 1/4" plate, and bolt up with 5 bolts per side. Very cool!